The level or straight edge is then placed along the other side of the bend, similar to the placement for the first line. A second line is then drawn on the conduit along the edge of the level or straight edge. If the bend in the conduit is small, the two lines should cross. This point is the center of the bend.Click to see full answer. In respect to this, how do you measure to bend conduit?Measure from the end of the conduit and make a mark at 7 inches to indicate the start of the bend. Slip the end of the conduit into the bender so the 7-inch mark is aligned with the arrow. This 7 inches, plus the “Stubs 5 to arrow” will give you the total horizontal run of 12 inches, including the bend.Furthermore, what is take up in conduit bending? Take up is a amount of conduit length used to figure out where to place the marks on the conduit before the bend. Most hand benders have the take up stamped on the bender or on a sticker – usually on the bender handle. Simply so, how do you measure and bend an EMT conduit? Slide the conduit into the bender leaving the appropriate amount past the arrow on the bending shoe. Now, pull the bender handle towards you to create the bend with a firm and steady motion to avoid any kinks or crimps in the conduit. Bend until you have reached your desired corner angle.How do you bend conduit around a tank?The number of conduit required to go all the way around the tank, or 360 degrees, is 6,049.53 / 118.25 = 51.16. Divide the total angle to go around the tank, 360 by the number of conduits required, 51.16, to get the angle required to bend each length of conduit. 360 / 51.16 = 7.04 degrees for each length of conduit.